Page 11 - 理化检验-物理分册2020年第二期

PHYSICAL TESTING 目次
AND
CHEMICAL ANALYSIS
PART A: PHYSICAL TESTING
Vol.56 No.2 (Monthly)
Feb. 2020
封面 - - - - - - - - - - - -
广 Uncertainty Evaluation on Resistivity of Round Wires of Copper Alloy by Measuring
告 LIU Zhiying, WANG Lei, RAO Jinwu, WANG Lili(10)
目 New Metallographic Test Method of Phase Transformation Temperatures of β-titanium
封二- - - - - - - - - - - - -
次 HE Wei, DU Xiaoping, SHI Kexue, ZHAI Tongde(15)
彩色内页(前插)-----(P1-16)
第 LIU Yunchuan, WANG Xuerong, YAO Kai, DUAN Jian(25)
期
彩色内页(后插)----(P17-20)
封三 - - - - - - - - - - - -
封底 - - - - - - - - - - - -
CONTENTS
Test and Investigation
Application of Coercivity Force in Pre-evaluation of Heat Treatment Quality
SHEN Zhengxiang, NIU Yaping, CHEN Hu, WANG Du,
Effect of Different Locations and Types of H Steel Section Samples on Tensile Test
CAI Penghui, WU Junlin, HU Yingjie(1)
Results WANG Manjuan, CHEN Bin, JIANG Jin(6)
Test Technique and Method
Sectional Area with Different Methods
Alloy MA Hongzheng, YANG Junhong,
Influence Factors of Roping Line of Aluminum Alloy Automobile Panel
WANG Liang, ZHANG Zedong, DU Min, XU Kun(21)
Measurement Uncertainty Evaluation on Verification/Calibration Process of
Thermogravimetric Analyzer WANG Qianqian, ZHOU Yanping,
Test Equipment and Application
Improvement and Application of Clamp of Repeated Bending Test
LIU Xibei, MA Hui, WANG Bin, ZHAO Jiangyong, JIN Baoyan(28)
Quality Control and Failure Analysis
Cause Analysis on Fracture of Overhead Ground Wire Based on Consideration of
Crimping Quality ZHANG Tao, XIE Liming, QIAO Xin,
ZHANG Xuechao, TAN Xiaomeng, SUN Yunfei(31)
Cause Analysis on Internal Defects of AgCuV Alloy Conductive Slip Ring
HAN Tianqi, QI Yuefeng, WANG Feng, JIAO Lei(35)
Cause Analysis on Cracking of 42CrMo Steel Worm
GAN Meilu, ZHANG Qiang, WANG Shuqiang, ZHOU Tao, MA Shuna(39)
Cause Analysis on Tube Burst of Superheater Tube of T91 Steel in Supercritical
Boiler BAI Jia, LIU Ming(44)
Cause Analysis on Fracture of Pantograph Torsion Spring Made of 0Cr17Ni7Al
Steel YU Huanwu, HUANG Sijun, XU Jun, XU Yufeng(48)
Cause Analysis on Cracking of Optical Module Reflector
LI Song, GENG Xue(52)
Cause Analysis on Cracking of Weld Seam of Dyeing Cylinder Heat Exchanger
XIE Xiaowu, LIU Kexiu, MA Kuo(55)
Failure Analysis on Cracking of Elastic Cylindrical Pin
HUANG Weifu, YE Zhenhua, LI Jianyu(58)
Cause Analysis on Pulling Out of f177.8 mm Casing with Buttress Thread
Connection in an Oil Well TENG Xueqing, ZHU Jinzhi,
Ü
L Shuanlu, HAN Yong, MA Lei, AI Yong(61)
Cause Analysis on Coating Surface Defects of Non-oriented Silicon Steel Plate
CHEN Man, ZOU Zhongkui(64)
Analysis on Leakage of BFe10-1-1 Cupronickel Tube of Heat Exchanger in Ultra
Supercritical Thermal Power Unit YANG Ping(67)
Sponsored by Shanghai Research Institute of Materials
Published by Periodical Office of Physical Testing and Chemical Analysis
Edited by Physical Testing Editorial Department, PTCA
Address: 99 Handan Road, Shanghai 200437, China
Tel: 0086-021-65556775 Ext.361
Fax: 0086-021-65544911
E-mail: pt@mat-test.com
Website: http://www.mat-test.com