Citation: | LYU Xiaoguang. Causes of quenching cracking in 42CrMoA round steel samples[J]. PHYSICAL TESTING AND CHEMICAL ANALYSIS PART A:PHYSICAL TESTING, 2024, 60(3): 56-59. DOI: 10.11973/lhjy-wl202403014 |
The sample of 42CrMoA round steel produced by a certain steel plant showed cracking phenomenon after quenching and tempering treatment. The causes of cracking in the sample were analyzed using methods such as macroscopic observation, chemical composition analysis, metallographic examination, hardness testing, scanning electron microscopy and energy spectrum analysis. The results show that the surface cracks of the sample were quenching cracks, and the crack source was located on the side near the center of the base material. The combined effects of short quenching insulation time, uneven organization of raw materials, segregation of Cr element composition and sulfide aggregation in the segregation zone led to quenching cracking of the sample.
[1] |
耿传芸,朱敏涛,杨学婧.35CrMo圆钢零件调质开裂原因分析[J].理化检验(物理分册),2015, 51(3):222-224.
|
[2] |
杨敏,崔冕,李占阳,等.回火温度对42CrMo钢金相组织及力学性能的影响[J].现代冶金,2019, 47(1):4-5.
|
[3] |
崔忠圻.金属学与热处理[M].北京:机械工业出版社,2020.
|
[4] |
丁惠麟,金荣芳.金属构件缺陷、失效分析与实例[M].北京:化学工业出版社,2020.
|